Nanoindentation analysis methods examined with finite element simulations

Artikel in diesem Heft

1. Contents
2. Contents
3. Original Contributions
4. Nanoindentation analysis methods examined with finite element simulations
5. Experimental investigation of gas/matte/spinel equilibria in the Cu–Fe–O–S system at 1250°C and P(SO₂) = 0.25 atm
6. Replacing martensite with nanobainite in moderately alloyed carburised steel for better wear performance
7. Microstructure, hardness and wear behaviour of NbC reinforced AA7075 matrix composites fabricated by friction stir processing
8. Microstructure, mechanical, and high-stress abrasive wear behaviour of as-cast and heat-treated Al–Si–SiCp composite
9. Mechanical and morphological properties of bamboo mesoparticle/nylon 6 composites
10. Particle and microstructural characteristics in the coarse-grained heat-affected zone of Al–Ti–Ca complex deoxidized steels
11. Corrosion behavior of stir-cast Al–TiB₂ metal matrix composites
12. Correlation between anodization variables and surface properties of titania nanotube arrays for dye-sensitized solar cells
13. Wetting and sealing of the interface between silicate glass and copper
14. Short Communications
15. Investigation of MWCNTs addition on mechanical properties of cordierite glass-ceramic composites
16. DGM News
17. DGM News